How to disconnect the jaw crusher

The most frequent repairment project of jaw crusher is to replace the thrust plate. For those connecting rod is a whole, if we want to remove the thrust plate, we must be wrung out the damper bolt first, and cut off the dry oil tube, make the thrust plate hanging on the crane lifting hook or other lifting equipment, then, we can loosen the horizontal spring at the end of the connecting rod, and remove the moving jaw to the direction of the fixed jaw and thrust the thrust plate.

After thrusting the thrust plate, we should cut off dilute lubricating oil pipe and cooling water pipe, with the bracket to make it live at the bottom of the connecting rod, then, thrust the connecting rod cap, finally, we get it. The jaw crusher's spindle should be removed with flywheel and pulley concurrently. Making the electromotor(together with the motor belt) along the slide rail to crusher nearer as far as possible, remove the triangle belt, then crane lift shaft. When removing the moving jaw, we must cut off the dry oil lubricating oil tube and rod firstly, and remove the bearing cover, and then, with a crane or other lifting equipment to move out of hubei.